KitchenAid 119 ユーザーズマニュアル

ページ / 19
9
Filling the dispenser
1. If the dispenser cover is closed, open the cover by pushing 
the cover latch.
2. Fill the Main Wash section with detergent. See “How Much 
Detergent to Use.”
3. Fill the Pre-Wash section, if needed.
4. Close the dispenser cover. 
It is normal for the cover to open partially when dispensing 
detergent.
NOTE: Use both sections for cycles with 2 washes. Use only the 
main wash section for cycles with 1 wash. See the “Cycle 
Selection Charts” for more details.
How much detergent to use
The amount of detergent to use depends on the hardness of 
your water and the type of detergent. If you use too little, 
dishes won’t be clean. If you use too much in soft water, 
glassware will etch.
Water hardness can change over a period of time. Find out 
your water’s hardness by asking your local water department, 
water softener company, or county extension agent.
You can order a water hardness test strip. In the 
U.S.A., call the Customer Interaction Center and ask for Part 
Number 4171690.
Different brands of dishwasher detergent have different 
amounts of phosphorus for softening water. If you have hard 
water and use a detergent with a phosphorous content of 
less than 8.7%, you might need to use more detergent, or use 
a detergent with a phosphorous content higher than 8.7%.
NOTE: Fill amounts shown are for standard powdered detergent. 
Amounts may vary if you use liquid or concentrated powdered 
detergent. Follow instructions on the package when using liquid 
dishwasher detergent or concentrated powdered detergent.
Water Hardness
Amount of Detergent
Soft to Medium 
Hard Water 
0 to 6 grains per 
gallon
For normally soiled loads
Partially fill the Main Wash 
section (5 tsp or 25 g)
Fill the Pre-Wash section 
(4 tsp or 20 g)
NOTE: Add only 2 tsp or 10 g of 
detergent to the Pre-Wash section if 
dishes are pre-rinsed or the water is 
very soft (0 to 2 grains per gallon).
For heavily soiled loads
Partially fill the Main Wash 
section (7 tsp or 35 g)
Fill the Pre-Wash section 
(4 tsp or 20 g)
Medium to Hard 
Water
7 to 12 grains per 
gallon
For normal and heavily 
soiled loads
Partially fill the Main Wash 
section (7 tsp or 35 g)
Fill the Pre-Wash section 
(4 tsp or 20 g)
Very Hard Water
13 grains per gallon 
and above
NOTE: It might be 
necessary to use the 
Heavy cycle, or a 
normal cycle with 
Hi-Temp Scrub, for 
best wash 
performance with 
very hard water.
For normally and 
heavily soiled loads
Fill the Main Wash section 
(8 tsp or 40 g)
Fill the Pre-Wash section 
(4 tsp or 20 g)
Turn the rinse aid dispenser to a 
higher setting. See “Rinse Aid 
Dispenser” later in this section.