Electrolux WT30H208DU ユーザーズマニュアル

10

Open the power supply terminal box and insert the jum-
pers provided as follows: two jumpers between terminals 
1, 3, 5 and another two between terminals 2, 4 and 6. 
Using a suitable power supply cable connect L1 and L2 to 
terminals 5 and 6 respectively and the ground wire to the 
terminal .

Open the power supply terminal box and insert the jum-
pers provided as follows: one jumper between terminals 1 
and 2, one between terminals 3 and 4 and another 
between terminals 5 and 6. Using a suitable power supply 
cable, connect the three phases to terminals 1, 3, 5, and 
the earth wire to the terminal 

.

Connections provided for energy control
This appliance is designed for an external energy con-
sumption control.

Connect the energy peak controller across terminals 11 
and 12.

Safety devices
• An automatic resettable thermally protectived device 

incorporated in the windings of the electric pump cuts 
off the electricity supply in the case of malfunctioning. 

• In the event of water mains failure, a back-flow 

device prevents water in the boiler from returning into 
the mains.

• An overflow pipe, connected to the drainage outlet, 

maintains the water in the tank at a constant level.

• On models with a drain pump, a supplementary level 

control device activates if the main level control 
device is faulty.

- Check that the shutoff valve is open.
- Check that the water inlet filter is clean.
- Check the minimum main pressure is not less than 

7.25 psi/50kPa. 

- Check that the overflow pipe is inserted (for applian-

ces without drain pump only).

- Check if the overflow has been removed.