Indesit NCAA 55 XX (UK) ユーザーズマニュアル

Your appliance is supplied with a 13amp fused plug that 
can be plugged into a 13amp socket for immediate use.  
Before using the appliance please read the instructions 
below.

Replacing fuse covers:
When replacing a faulty fuse, a 13amp ASTA approved 
fuse to BS 1362 should always be used and the fuse 
cover re-fitted.
If the fuse cover is lost, the plug must not be used until a 
replacement is obtained.

Replacement fuse covers:
If a replacement fuse cover is fitted, it must be of the 
correct colour as indicated by the coloured marking or the 
colour that is embossed in words on the base of the plug.

Removing the plug
If your appliance has a non-rewireable moulded plug and 
you should wish to remove it to add a longer cable or 
to re-route the mains cable through partitions, units etc. 
please ensure that either:
-  The plug is replaced by a fused 13amp re- 

 

wireable plug bearing the BSI mark of  

 

 approval.

or
-  The mains cable is wired directly into a  

 

 

13amp cable outlet, controlled by a  

 

 

switch (in compliance with BS 5733)  

 

 

which is accessible without moving the    

 appliance.

Disposing of the plug
Cut off and dispose of the supplied plug if it does not 
fit your socket. The cable should be cut as close as 
possible to the moulded plug.
Remove the fuse.

IMPORTANT:  
WIRES IN THE MAINS LEAD ARE COLOURED IN 
ACCORDANCE WITH THE FOLLOWING CODE...

Green and Yellow  - Earth

Blue 

 

- Neutral

Brown 

 

- Live

As the colours of the wires in the mains lead may not 
correspond with the coloured markings identifying the 
terminals in your plug, proceed as follows:
-  Connect Green and Yellow wire to  

terminal 

marked ‘E’ or  

   or coloured Green and Yellow.

-  Connect Brown wire to terminal marked ‘L’ or 

coloured red or brown.

-  Connect Blue wire to terminal marked ‘N’  or coloured 

Black or Blue.

If a 13amp plug (BS 1363) is used it must be 
fitted with a 13amp fuse.  A 15amp plug must be 
protected by a 15amp fuse, either in the plug or adaptor 
or at the distribution board.