Amana ARR6400/ART6511 ユーザーズマニュアル
10
Operating Surface Elements
WARNING
To avoid risk of serious personal injury, property
damage, or fire, do not leave surface elements
unattended while in operation. Grease and spillovers
can ignite causing a fire.
damage, or fire, do not leave surface elements
unattended while in operation. Grease and spillovers
can ignite causing a fire.
1.
Push in and turn surface element control to desired
setting.
setting.
(Figure 11)
• Some ranges have two indicator lights, one for
elements on right side and one for elements on left
side of range. When either front or rear element is
on, corresponding indicator light glows.
side of range. When either front or rear element is
on, corresponding indicator light glows.
• Smoothtop ranges can have four indicator lights.
After the surface controls are turned off, the
appropriate surface indicator light will continue to
glow until the surface elements have cooled.
The length of time each light remains on will vary.
Do not expect the lights for two different heating
areas to go off at the same time even if the
elements were turned off simultaneously.
appropriate surface indicator light will continue to
glow until the surface elements have cooled.
The length of time each light remains on will vary.
Do not expect the lights for two different heating
areas to go off at the same time even if the
elements were turned off simultaneously.
2.
When finished cooking, turn control to
OFF position.
OFF
LO
HI
MED
Surface element control knobs
Figure 11
Operation
Converting 3-Wire to 4-Wire Power Cord
1.
Remove rear wire cover.
2.
Remove bottom strain relief screw and retain for
further use.
further use.
3.
Remove screw/hex nuts from terminal block and
retain for further use.
retain for further use.
4.
Remove all 3-wire or cable leads from the terminal
block and proceed to remove the power cord from the
range by pulling in a downward motion so the cord is
removed from strain relief.
block and proceed to remove the power cord from the
range by pulling in a downward motion so the cord is
removed from strain relief.
5.
To install the 4-wire cord, please follow step 3 through
step 9 of
step 9 of
Installing 4-Wire Power Cord section.
Level Range
CAUTION
To avoid damaging oven door, do not lift or move range
by oven door handle. Glass can break.
by oven door handle. Glass can break.
Carefully level range using legs provided. Range must be
level to cook and bake uniformly.
• Place a level on top oven rack or on range top when
level to cook and bake uniformly.
• Place a level on top oven rack or on range top when
leveling.
• Leveling legs must extended ¼ inch to engage anti-tip
bracket.
Removal and Replacement of Range
1.
Disconnect power to range.
2.
Slide range forward.
3.
Unplug range cord and place range aside.
4.
Remove anti-tip bracket.
5.
Install anti-tip bracket into new location using
instructions provided with bracket or see
instructions provided with bracket or see
Anti-tip
Bracket Installation section in this manual.
6.
To reinstall range, follow instructions in
Installation
section of this manual.