Seagate ST136403LW/LC ユーザーズマニュアル
30
Cheetah 36 Installation Guide, Rev. A
LC model installation
1.
Set the SCSI ID on the drive.
Determine which SCSI IDs are already being used in the
system and then assign the disc drive a SCSI ID that isn’t
already being used. Use the J6 connector located on the
front of the drive to set the SCSI ID (see Figure 12).
Determine which SCSI IDs are already being used in the
system and then assign the disc drive a SCSI ID that isn’t
already being used. Use the J6 connector located on the
front of the drive to set the SCSI ID (see Figure 12).
• This drive is SCAM (SCSI Configured Auto
Magically) compliant. If you are installing this
drive in a SCAM compliant system, you can skip
drive in a SCAM compliant system, you can skip
this step because the system automatically assigns the
drive SCSI ID.
drive SCSI ID.
• The host system’s SCSI controller usually uses SCSI ID 7
so this SCSI ID is not usually available for disc drives or
other devices.
other devices.
• Most ST136403LC drives are factory set with the SCSI ID
set at 0. If this is the only SCSI drive in your system and
there are no other SCSI devices on the daisychain, you can
leave this drive’s SCSI ID set to 0 and proceed to the next
step. A device is any hardware other than an inline termina-
tor that is connected to the SCSI cable.
there are no other SCSI devices on the daisychain, you can
leave this drive’s SCSI ID set to 0 and proceed to the next
step. A device is any hardware other than an inline termina-
tor that is connected to the SCSI cable.