Frigidaire FGHB2844LF ユーザーズマニュアル

12



Do not remove center screw from freezer 
drawer.  This is a factory adjustment.

Drawer is heavy.  Use caution when lifting.

1.  Lift drawer up and out to remove.

1.  With lower slides pulled out, hang 

drawer onto slide brackets ensuring 

pins on each side are fully inserted into 

slots on each side.

2.  Reinstall four (4) drawer screws (two 

(2) per side), tighten down, and close 

drawer (C).

3.  Check gasket seal around top, bottom, 

and sides of freezer drawer.

4.  If gasket is not sealed, open drawer 

and slightly loosen four (4) drawer 

screws (two (2) on each side) to allow 

drawer to rotate.

5.  Close drawer and recheck the seal 

on the gasket (A).  Open the drawer 

grabbing by the sides in the center (B).  

Be careful not to rotate the drawer.

 

6.  Tighten four (4) drawer screws.

7.  Recheck gasket seal.

8.  Install the toe grille by fitting into

place.