Frigidaire 297298700 ユーザーズマニュアル

6

1.  Remove handle from carton and any other 

protective packaging. 

2.   Position refrigerator handle end caps over upper 

and lower pre-installed shoulder bolts (A) that 
are fastened into door, ensuring the holes for the 
set screws are facing towards the outside of door 
if a single unit installation or the freezer door (if 
installing the matching freezer) 

3.   While holding handle fi rmly against door, fasten 

upper and lower Allen set screws (B) with supplied 
Allen wrench. 

4.   Repeat steps 2 and 3 to install freezer handle 

(if installing the matching freezer).  Ensure the 
holes for the set screws are facing towards the 
refrigerator door.

To remove the kick plate, use a Phillips head 
screwdriver and remove the two screws holding the 
kick plate to the cabinet.  Then pull the kick plate 
away from the unit.

The refrigerator must have all bottom corners resting 
fi rmly on a solid fl oor.
The fl oor must be strong enough to support a fully 
loaded refrigerator.  
It is VERY IMPORTANT for your refrigerator to be level 
in order to function properly.  If the refrigerator is not 
leveled during installation, the door may be misaligned 
and not close or seal properly, causing cooling, frost 
or moisture problems.

Leveling instructions continued on next page.



All set screws should be tightened and sub-fl ush (Allen 
set screw should be seated just below the surface of 
the end cap) of handle end cap.  The end caps should 
be drawn tight to refrigerator door with no gaps.

A

B