Frigidaire 297298700 ユーザーズマニュアル

7

While unit is lying on its back for wood skid removal, 
note the location of the four (4) leg levelers installed at 
each corner.  These leg levelers will be used to level the 
refrigerator and to adjust the height.  Use a carpenter’s 
level to level the refrigerator from front to back and side 
to side.  

•   Level door of fi rst unit using all four levelers and slide 

unit into place.  Recheck for levelness and adjust if 
necessary.

•   Measure distance from fl oor to bottom of door on 

fi rst unit.  Adjust and level second unit so door height 
matches. 

•   Leg Level Adjustments:
•   One full turn of all four leg levelers will raise door 

5/32”.

•   Slide second unit into place leaving a minimum 
 

gap of 3/16” between units for door swing clearance.

•   This last step may require at least one extraction of 

the second unit to properly align units in a “built-in” 
application.  

Use the lower hinge adjustment to fi ne tune the door 
height and for fi nal cabinet spacing.   Use a 7/16” socket 
or wrench to adjust the screw at the bottom of the lower 
hinge. 

The doors may also be adjusted side to side with the 
slotted hinge for aligning the doors parallel to each other.  
Loosen the two bolts with a 3/8” wrench and one screw 
with a Phillips screwdriver.  Shift the doors until parallel, 
then retighten the screws securely.  (See illustration 
below.)

Refrigerator

Freezer

3/8” Bolts

Screw

To level the doors using the adjustable lower hinge (some 
models): 
1.   If the refrigerator door is lower than the freezer door, 

raise the refrigerator door by turning the adjustment 
screw clockwise using a 7/16 inch socket wrench. 
(See illustration below.) 

2.   If the freezer door is lower than the refrigerator door, 

raise the freezer door by turning the adjustment 
screw clockwise using a 7/16 inch socket wrench. 
(See illustration below.)



Make sure to allow for the Trim and Leveling Kit if it is 
to be installed with the unit.