Mitsubishi Electronics FR-F700-NA ユーザーズマニュアル

 appears...Why? 

Parameter read error. Perform operation from step 3 again.

 appears...Why? 

Parameter write error. Perform operation from step 8 again.

 and 

 flicker alternately

Appears when parameters are copied between the inverter of FR-F720-02330 (FR-F740-01160) or less and FR-

F720-03160 (FR-F740-01800) or more.

1. Set "0" in Pr. 160 User group read selection.

2. Set the following setting (initial value) in Pr. 989 Parameter copy alarm release.

3. Reset Pr. 9, Pr. 30, Pr. 51, Pr. 52, Pr. 54, Pr. 56, Pr. 57, Pr. 70, Pr. 72, Pr. 80, Pr. 90, Pr. 158, Pr. 190 to Pr. 196, Pr. 557,

Pr. 893.

Whether same parameter values are set in other inverters or not can be checked.

When the copy destination inverter is not the FR-F700 series, "model error (

)" is displayed.

 flickers ... Why?

Set frequencies, etc. may be different. Check set frequencies.

Pr. 989 Setting

10

100

• Hold down        to verify.

2.

Screen at powering ON

     The monitor display appears.

Display

Operation

7.

Press         to read the parameter setting

     of the verified inverter to the operation panel.

1.

Move the operation panel to the  

     inverter to be verified.

• Move it during a stop.

4.

Turn        until              (parameter copy) 

     appears.

6.

Turn       to change it to the set value

     "   "(parameter copy verification mode).

8.

If there is no difference,              and   

     flicker to complete verification.

The frequency flickers
for about 30s

Flickering

 • If different parameters exist, different 
    parameter numbers and           flicker.

The parameter 
number read
 previously appears.

5.

Press         to read the present set

     value.

     "    "(initial value) appears.

3.

Press        to choose the parameter 

     setting mode.