Makita DCS461 ユーザーズマニュアル
21
1
2
D
4/5
E
F
Chain typ
086, 484, 686, 099
Chain typ
093
Files and how to work with them
Use a special saw chain round Þ le for sharpening. Standard round
Þ les are unsuitable. For the order number, see “Accessories”.
Þ les are unsuitable. For the order number, see “Accessories”.
Type 086, 484, 686: File the Þ rst cutter half with a 4,8 mm dia.
round saw-chain Þ le, then switch to a 4.5 mm dia. Þ le.
round saw-chain Þ le, then switch to a 4.5 mm dia. Þ le.
Type 093, 099: File the Þ rst cutter half with a 5,5 mm dia. round
saw-chain Þ le, then switch to a 4.8 mm dia. Þ le.
saw-chain Þ le, then switch to a 4.8 mm dia. Þ le.
The Þ le should cut only when pushed forwards (arrow). Lift the
Þ le when leading it backwards.
Þ le when leading it backwards.
First sharpen the shortest cutter. The length of this cutter is then
the standerd for all other cutters of the chain.
the standerd for all other cutters of the chain.
New saw teeth must be Þ led to the exact same shape as the
used teeth, including on their running surfaces.
used teeth, including on their running surfaces.
File depending on chain type (90° or 10° to the guide bar).
A Þ le holder makes Þ le guidance easier. It is marked for the
correct sharpening angle of:
correct sharpening angle of:
α = 25°
α = 30°
α = 35°
(keep the marks parallel with the chain when Þ ling, see illustration)
and limits the cut depth to the correct 4/5 of the Þ le diameter.
See „Accessories“ for the order number.
and limits the cut depth to the correct 4/5 of the Þ le diameter.
See „Accessories“ for the order number.
After having sharpened the chain, the height of the depth limiter
must be checked by means of a chain gauge. See „Accessories“
for the order number.
must be checked by means of a chain gauge. See „Accessories“
for the order number.
Correct even the smallest excess height with a special ß at
Þ le (1). See „Accessories“ for the order number.
Þ le (1). See „Accessories“ for the order number.
Round off the front of the depth limiter (2).
α