Makita DCS461 Manual Do Utilizador

21

4/5

Chain typ

086, 484, 686, 099

Chain typ

093

Use a special saw chain round Þ le for sharpening. Standard round 
Þ les are unsuitable. For the order number, see “Accessories”.

Type 086, 484, 686: File the Þ rst cutter half with a  4,8 mm  dia. 
round saw-chain Þ le, then switch to a 4.5 mm dia. Þ le.

Type 093, 099: File the Þ rst cutter half with a  5,5 mm  dia. round 
saw-chain Þ le, then switch to a 4.8 mm dia. Þ le.

The Þ le should cut only when pushed forwards (arrow). Lift the 
Þ le when leading it backwards.

First sharpen the shortest cutter. The length of this cutter is then 
the standerd for all other cutters of the chain.

New saw teeth must be Þ led to the exact same shape as the 
used teeth, including on their running surfaces.

File depending on chain type (90° or 10° to the guide bar).

A  Þ le holder makes Þ le guidance easier. It is marked for the 
correct sharpening angle of: 

 

α = 25°

 

α = 30°

 

α = 35°

(keep the marks parallel with the chain when Þ ling, see illustration) 
and limits the cut depth to the correct 4/5 of the Þ le diameter. 
See „Accessories“ for the order number.

After having sharpened the chain, the height of the depth limiter 
must be checked by means of a chain gauge. See „Accessories“ 
for the order number.

Correct even the smallest excess height with a special ß at 
Þ le (1). See „Accessories“ for the order number.

Round off the front of the depth limiter (2).

α