Belkin 8000I ユーザーズマニュアル

 

 

25

Northstar 8000i System - 12" Display Processor Installation Manual 

 

Location Guide 

Locate the keypad relative to the screen it is controlling. The keypad does not require 
external power 

Mounting 

Select an area that has easy access in order to control the 8000i. Make sure the panel it is 
being mounted into is flat, to ensure a watertight seal 

 

 

 

Description 

Video to USB converter 

Functionality 

Interfaces composite or S-Video feeds to a 8000i processor. Composite or S-Video can be 
from a security camera or a an entertainment source. It is converted to a USB feed which 
connects to a 8000i possessor or USB hub. The feed is then displayed on the 8000i processor 
it is connected to. The video is not networked. It is only visible on the local processor. The 
device can use NTSC PAL or SECAM. Select which source you use from with in the 8000i 
software. 

NOTE: Only one video capture device can be used per processor 

Other parts required 

Third party video feed. If using audio; connect the audio feed of the device to NS004802 
audio cable which then connects to the Aux connector of the processor 

Location Guide 

Connect to a 8000i processor. Don't use a USB cable longer than 16.5 ft (5 m). Pay special 
attention to the video and audio cable runs. Refer to wiring guide (see "Wiring  Guidelines" 
page 37) 

 

 

 

 

Description 

C-Map Chart License Key 

Functionality 

Holds the license information of the purchased charts.