Mitsubishi Electronics E60 ユーザーズマニュアル

I - 11 

 

The feed hold state been entered due to a condition in the 
automatic operation. 

Error No. 

Details 

Remedy 

H/W STRK END (H/W stroke end axis) 

An axis is at the stroke end. 

•  Manually move the axis away from the 

stroke end limit switch. 

•  The machining program must be 

corrected. 

S/W STRK END (S/W stroke end axis) 

An axis is at the stored stroke limit. 

•  Manually move the axis. 
•  The machining program must be 

corrected. 

RESET SIGNAL ON (Reset signal on) 

The reset signal has been input. 

•  The program execution position has 

returned to the start of the program. 
Execute automatic operation from the 
start of the machining program. 

AUTO OP STOP (Automatic operation 
stop) 

The FEED HOLD switch is "ON". 

•  Resume automatic operation by 

pressing the "CYCLE START" switch. 

AUTO MD CHING (Automatic mode 
change) 

The operation mode changed to another 
mode during automatic operation. 

•  Return to the original automatic 

operation mode‚ and resume automatic 
operation by pressing the "CYCLE 
START" switch. 

Acceleration and deceleration time 
constants too large 

The acceleration and deceleration time 
constants are too large.  (This problem 
occurs at the same time as system 
alarm Z59.) 

•  Increase the set value of the parameter 

"#1206 G1bF". 

•  Decrease the set value of the parameter 

"#1207 G1btL". 

•  Lower the cutting speed. 

Absolute position detection alarm stop 

An absolute position detection alarm 
occurred. 

•  Reset the absolute position detection 

alarm.