Combi 8000 Series ユーザーズマニュアル

This infant car seat can only be used with COMBI stroller models to transport your infant.

Check COMBI stroller information or the COMBI International website at www.combi-intl.com,
for an updated list of stroller models.

See stroller instructions for securing car seat and use information.

Shoulder harness straps must be through slots at or just below shoulder.

To change shoulder belt slots:

1. Buckle harness and chest clip.

2. From front of car seat, loosen harness straps by pressing harness adjuster lever and 

pulling harness straps out to lengthen them.  

3. From back of car seat, rotate harness safety cover out, unhook both harness 

strap metal clips from adjuster loop (fig. a).

4. From front of car seat, pull harness straps out through car seat shell, seat pad 

and infant insert.

To Re-secure Harness Belts:

1. From front of car seat, rethread harness straps through desired harness strap 

slots of infant insert, seat pad and seat back.

NOTE: Only use two lowest sets of shoulder belt slots with infant insert.

2. From back of car seat, route shoulder belts between plastic seat 

and metal rod.  Pull harness straps down and re-attach harness 
strap metal clips to adjuster loop as shown in fig. c.  Make sure 
harness straps are not twisted and are threaded through 
matching slot of seat pad and seat back.  

3. Close harness safety cover, snap onto metal rod. 22