Combi 8000 Series ユーザーズマニュアル

Harness Use and Adjustment

Harness Strap Adjustment:

• To tighten: Pull front adjuster strap (fig. a).

• To loosen: While pressing harness adjuster lever, pull harness

straps out.

Chest Clip Operation:

• To open: Press tabs and pull apart (fig. b).

• To close: Snap halves together. Make sure chest clip is locked

by pulling out.

Carry Handle Operation -

Carry handle has three positions (fig. c):

A. Carrying position
B. Vehicle use position and rocking position
C. Reclined seat position

To change carrying handle position:

• Push in handle buttons on each side of handle (fig. d).

• Rotate handle forward or backward until it locks into the

proper use position.

IMPORTANT: Check to be sure carry handle is locked
before lifting car seat.

(fig. b)

(fig. c)

(fig. d)

Harness

Adjuster

Lever

(Under

Pad)

(fig. a)

Harness

Adjuster

Strap

Handle
Buttons

Base Adjustment:

Turn recline adjustment knob to raise base (fig. a).

Push-in red recline adjustment button at center of recline adjustment knob and turn
knob to lower base.

Infant Insert:

Canopy:

Secure snaps on side of canopy to seat pad, hook canopy over back of car seat and
pull canopy forward (fig. b).

WARNING

• To prevent ejection:

Shoulder belts MUST be through belt slots in infant insert.
- For proper harness fit, infant insert MUST be used for small infants.

• Discontinue use of infant insert when:

- Child’s shoulders are above middle belt slots in seat back of car seat.
- Shoulder belts become too short to fit infant (approximately 5 months of age).

(fig. a)

(fig. b)