Multitech MTCBA-Xx-EN2-GP ユーザーズマニュアル
Chapter 3 – Using the Web Management Software
MultiModem rCell User Guide
77
Serial-Port, Serial Port Settings Parameters
Serial-Port Configuration Group
Serial-Port Configuration lets you configure the serial terminal connected to the RS-232 connector DE9 on the
back of the unit.
back of the unit.
Baud Rate:
Sets the baud-rate at which the serial terminal is communicating. The default is 115200.
Flow Control:
Sets the flow control for the serial port. Options are None or RTS-CTS. The default is None.
Data Bits:
Sets the data bits for the serial port. Data bit selection is 7 or 8. The default is 8.
Stop Bits:
Sets the stop bits for the serial port. Options are 1 or 2. The default is 1.
Parity:
Sets the parity for the serial port. Options are None, Even, or Odd. The default is None.
Buffer Length:
Sets the length up to which the data from the serial device is buffered before IP transmission. The
default length is 32-characters.
Timeout:
Sets the timeout value for the serial terminal of how long it waits before IP transmission. The default is
1-second.
Submit Button:
Click Submit to save these settings.
Power Management Configuration Group
Configures when the processor or radio is placed in low power mode. The device only wakes up when there is data on the
serial port. If there is no data on the serial port, and the amount of time that you specify in the Timer option is expired, then
the processor or radio goes into low power mode.
serial port. If there is no data on the serial port, and the amount of time that you specify in the Timer option is expired, then
the processor or radio goes into low power mode.