Ariston OK 997E LDP AUS S ユーザーズマニュアル

•  The stainless steel or enamel-coated external parts and 

the rubber seals may be cleaned using a sponge that 
has been soaked in lukewarm water and neutral soap. 
Use specialised products for the removal of stubborn 
stains. After cleaning, rinse and dry thoroughly. Do not 
use abrasive powders or corrosive substances.

•  The inside of the oven should ideally be cleaned after 

each use, while it is still lukewarm. Use hot water and 
detergent, then rinse well and dry with a soft cloth. Do 
not use abrasive products.

•  All accessories - with the exception of the sliding racks 

- can be washed like everyday crockery, and are even 
dishwasher safe.

•  We recommend that detergents are not sprayed directly 

onto the control panel, but that a sponge is used instead.

 Never use steam cleaners or pressure cleaners on the 

appliance.

Clean the glass part of the oven door using a sponge and 
a non-abrasive cleaning product, then dry thoroughly with a 
soft cloth. Do not use rough abrasive material or sharp metal 
scrapers as these could scratch the surface and cause the 
glass to crack. For more thorough cleaning purposes, the 
oven door may be removed:
1. Open the oven door fully (see diagram).
2. Use a screwdriver to lift up and turn the small levers 

 

located on the two hinges (see diagram).

 

3. Grip the door on the two outer 
sides and close it approximately 
half way. Pull the door towards you, 
lifting it out of its slot (see diagram). 
To replace the door, reverse this 
sequence.

Inspecting the seals
Check the door seals around the oven regularly. If the seals 
are damaged, please contact your nearest Service Centre 
(see Assistance). We recommend that the oven is not used 
until the seals have been replaced.

To replace the oven light 
bulb:
1. Remove the glass cover 
of the lamp-holder.
2. Remove the light bulb and 
replace it with a similar one: 
halogen lamp voltage 230 V, 
wattage 25 W, cap G 9.
3. Replace the glass cover 
(see diagram).

 Do not touch the light bulb directly with your hands.

 Do not use the oven lamp as/for ambient lighting.

To assemble the sliding 
racks:
1. Remove the two frames, 
lifting them away from the 

spacers A (see figure).

2. Choose which shelf to use 
with the sliding rack. Paying 
attention to the direction in 
which the sliding rack is to 
be extracted, position joint B 
and then joint C on the 
frame.

3. Secure the two frames 
with the guide rails using the 
holes provided on the oven 
walls (see diagram). The 
holes for the left frame are 
situated at the top, while the 
holes for the right frame are 
at the bottom.

4. Finally, fit the frames on 

the spacers A.

 Do not place the sliding racks in position 5.

Glass cover

Lamp

Lamp 
Holder 
compartment

Left
guide rail

Right guide
rail

Direction

of extraction