Cirkuit Planet ICA-108W ユーザーズマニュアル
•ASCII - In this method the string must be exactly 5
characters for 64-bit WEP and 13 characters for
128-bit WEP.
characters for 64-bit WEP and 13 characters for
128-bit WEP.
•HEX - In this method the string must be exactly 10
hexadecimal (0-9, A-F) characters for 64-bit WEP
and 26 hexadecimal characters for 128-bit WEP.
hexadecimal (0-9, A-F) characters for 64-bit WEP
and 26 hexadecimal characters for 128-bit WEP.
Web Key 1~4:
Key value of WEP.
WPA
settings:
settings:
WPA Key: Key value of WPA. The device uses a
pre-shared key (PSK) for key management. The
pre-shared key can be entered either as Manual
hex, as 64 hexadecimal characters, or as a
Passphrase, using 8 to 63 ASCII characters.
pre-shared key (PSK) for key management. The
pre-shared key can be entered either as Manual
hex, as 64 hexadecimal characters, or as a
Passphrase, using 8 to 63 ASCII characters.
SSID:
This is the name of the wireless network the device is configured for. The
field accepts up to 32 alphanumeric characters. The name must be
exactly the same as that used in the wireless access point, or the
connection will not be established.
field accepts up to 32 alphanumeric characters. The name must be
exactly the same as that used in the wireless access point, or the
connection will not be established.
Leaving this field blank means the device will attempt to access the
nearest open network.
nearest open network.
Channel:
Chooses the wireless channel in use currently.
Obtain IP address
automatically
(DHCP):
automatically
(DHCP):
Enable this checked box when a DHCP server is installed on the network
to issue IP address assignment. With this setting, the IP address is
assigned automatically.
to issue IP address assignment. With this setting, the IP address is
assigned automatically.
IP address, Subnet
mask, and
Gateway:
mask, and
Gateway:
If you do not select Obtain an IP address automatically, then you need to
enter these network parameters manually.
enter these network parameters manually.
IP Address:
This address is a unique numbers that identifies a computer or device on
the WAN or LAN. These numbers are usually shown in groups separated
by periods, for example: 192.168.0.200
the WAN or LAN. These numbers are usually shown in groups separated
by periods, for example: 192.168.0.200
Subnet Mask:
Subnets allow network traffic between hosts to be separated based on
the network's configuration. In IP networking, traffic takes the form of
packets. IP subnets advance network security and performance to some
level by organizing hosts into logical groups. Subnet masks contain four
bytes and usually appear in the same "dotted decimal" data. For
example, a very common subnet mask in its binary demonstration
11111111 11111111 11111111 00000000 will usually be shown in the
corresponding, more readable form as 255.255.255.0.
the network's configuration. In IP networking, traffic takes the form of
packets. IP subnets advance network security and performance to some
level by organizing hosts into logical groups. Subnet masks contain four
bytes and usually appear in the same "dotted decimal" data. For
example, a very common subnet mask in its binary demonstration
11111111 11111111 11111111 00000000 will usually be shown in the
corresponding, more readable form as 255.255.255.0.
Gateway:
A gateway is a piece of software or hardware that passes information
between networks. You'll see this term most often when you either log in
to an Internet site or when you're transient email between different
servers.
between networks. You'll see this term most often when you either log in
to an Internet site or when you're transient email between different
servers.
Note:
To enable WLAN function, user must set these related parameters correctly at first.
Then power off the ICA-108W and remove Ethernet cable from ICA-108W. Power on
the ICA-108W again and WLAN mode will be available accordingly.
Then power off the ICA-108W and remove Ethernet cable from ICA-108W. Power on
the ICA-108W again and WLAN mode will be available accordingly.
37