ATTO Technology 1180D ユーザーガイド

14

Installation: FibreBridge 1290E

LED indicators
The faceplate shows two dual-stacked LEDs and 
a single LED. The green dual-stacked LED 
indicates FC activity, the other FC link speed. 
Another green dual-stacked LED indicates SCSI 
activity on each of the SCSI ports, and the single 
LED indicates Ready status.

The LED blinks to show activity on 

the Fibre Channel port (numbered 0). During very 

high activity, the LED may appear to be steadily 
lit.

a lit LED indicates the 

FibreBridge is using 2-Gigabit. 

shows activity on the SCSI bus 

(numbered 0 and 1).

should light after power has been applied 

to indicate the board has completed the 
initialization process without any failures and is 
ready to handle data transfers.

1

Mount the FibreBridge in your device.

2

Connect a SCSI device to the FibreBridge. 
Connect the Fibre Channel port to your 
SAN.Connect the Ethernet cable from the Fibre 
Bridge to your computer. Refer to 

3

Connect the power connector.

4

Apply power.

5

Access FibreBridge Services using the 
QuickNAV utility. Refer to 

6

Go to the ExpressNAV Restart page and 
restart the FibreBridge.

7

Map your devices.Refer to 

8

Boot the computers on the SAN and check the 
configuration. Refer to