Alcatel-Lucent 6850-48 ネットワークガイド

Modifying Static Aggregation Group Parameters

Configuring Static Link Aggregation

page 22-10

OmniSwitch AOS Release 6 Network Configuration Guide

This section describes how to modify the following static aggregate group parameters:

• Static aggregate group name (see 

)

• Static aggregate group administrative state (see 

)

The following subsections describe how to modify the name of the static aggregate group with the 

 command.

To create a name for a static aggregate group by entering static linkagg followed by the number of the 
static aggregate group, name, and the user-specified name of the group, which can be up to 255 characters 
long. For example, to configure static aggregate group 4 with the name “Finance” you would enter:

-> static linkagg 4 name Finance

Note. If you want to specify spaces within a name for a static aggregate group the name must be specified 
within quotes (e.g., “Static Aggregate Group 4”).

To remove a name from a static aggregate group you use the no form of the 

command by entering static linkagg followed by the number of the static aggregate group and no name. 
For example, to remove any user-specified name from static aggregate group 4 you would enter:

-> static linkagg 4 no name

By default, the administrative state for a static aggregate group is enabled. The following subsections 
describe how to enable and disable the administrative state with the 

 command.

To enable a static aggregate group by entering static linkagg followed by the number of the group and 
admin state enable. For example, to enable static aggregate group 1 you would enter:

-> static linkagg 1 admin state enable

To disable a static aggregate group by entering static linkagg followed by the number of the group and 
admin state disable. For example, to disable static aggregate group 1 you would enter:

-> static linkagg 1 admin state disable