Alcatel-Lucent 6850-48 ネットワークガイド

Configuring Dynamic Link Aggregate Groups

Configuring Dynamic Link Aggregation

page 23-10

OmniSwitch AOS Release 6 Network Configuration Guide

This section describes how to use Alcatel-Lucent’s Command Line Interface (CLI) commands to create, 
modify, and delete dynamic aggregate groups. See 

 for more information.

Note. See 

 for a brief tutorial on 

configuring these mandatory parameters.

Alcatel-Lucent’s link aggregation software is preconfigured with the default values for dynamic aggregate 
groups and ports shown in the table in 

. For 

most configurations, using only the steps described in 

 will be necessary to configure a dynamic link aggregate group. However, if you 

need to modify any of the parameters listed in the table on 

, please see 

 for more information.

Note. See the “Link Aggregation Commands” chapter in the OmniSwitch CLI Reference Guide for 
complete documentation of show commands for link aggregation.

When configuring LACP link aggregates on a switch you must perform the following steps:

1 Create the Dynamic Aggregate Groups on the Local (Actor) and Remote (Partner) Switches. To 
create a dynamic aggregate group use the 

 command, which is described in 

.

2 Configure the Same Administrative Key on the Ports You Want to Join the Dynamic Aggregate 
Group. To configure ports with the same administrative key (which allows them to be aggregated), use 
the 

 command, which is described in 

.

Note. Depending on the needs of your network you may need to configure additional parameters. 
Commands to configure optional dynamic link aggregate parameters are described in 

.These commands must be executed after you 

create a dynamic aggregate group.