Alcatel-Lucent 6850-48 ネットワークガイド

Configuring Dynamic Link Aggregation

Configuring Dynamic Link Aggregate Groups

OmniSwitch AOS Release 6 Network Configuration Guide

page 23-11

The following subsections describe how to create and delete dynamic aggregate groups with the 

To configure a dynamic aggregate group, enter lacp linkagg followed by the user-configured dynamic 
aggregate number (which can be from 0 to 31), size, and the maximum number of links that will belong to 
this dynamic aggregate group, which can be 2, 4, or 8. For example, to configure the dynamic aggregate 
group 2 consisting of eight links enter:

-> lacp linkagg 2 size 8

You can create up to 32 link aggregation (both static and dynamic) groups per a standalone switch or a 
stack of switches. In addition, you can also specify optional parameters shown in the table below. These 
parameters must be entered after size and the user-specified number of links.

For example, Alcatel-Lucent recommends assigning the actor admin key when you create the dynamic 
aggregate group to help ensure that ports are assigned to the correct group. To create a dynamic aggregate 
group with aggregate number 3 consisting of two ports with an admin actor key of 10, for example, enter:

-> lacp linkagg 3 size 2 actor admin key 10

Note. The optional keywords for this command may be entered in any order as long as they are entered 
after size and the user-specified number of links.

To remove a dynamic aggregation group configuration from a switch use the no form of the 

 command by entering no lacp linkagg followed by its dynamic aggregate group number.

For example, to delete dynamic aggregate group 2 from a switch’s configuration you would enter:

-> no lacp linkagg 2

Note. You cannot delete a dynamic aggregate group if it has any attached ports. To remove attached ports 
you must disable the dynamic aggregate group with the 

 command, which is 

described in