Alcatel-Lucent 6850-48 参照ガイド
Virtual Private LAN Service (VPLS) Commands
OmniSwitch CLI Reference Guide
September 2009
page 26-45
configure service vpls mesh-sdp egress vc-label
Configures the static MPLS VC label used by this router to send packets to the far-end router using the
specified mesh SDP binding.
specified mesh SDP binding.
configure service vpls service-id mesh-sdp sdp-id[:vc-id] egress vc-label egress-vc-label
configure service vpls service-id no mesh-sdp sdp-id no egress vc-label
Syntax Definitions
service-id
An existing VPLS ID number.
sdp-id
An existing SDP ID number that is bound to the specified service ID
number.
number.
vc-id
A VC ID number used to validate the VC ID portion of each mesh SDP
binding defined for the service.
binding defined for the service.
egress-vc-label
The egress VC value that identifies a specific connection. The valid
range is 16–1048575.
range is 16–1048575.
Defaults
By default, the egress VC label value is set to zero (0).
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
Use the no form of this command to remove the egress VC label from the specified VPLS.
Examples
-> configure service vpls 100 mesh-sdp 20 egress vc-label 131070
-> configure service vpls 100 mesh-sdp 20 egress no vc-label
Release History
Release 6.4.2; command was introduced.
parameter
default
vc-id
service-id value