Alcatel-Lucent 6850-48 参照ガイド
Virtual Private LAN Service (VPLS) Commands
OmniSwitch CLI Reference Guide
September 2009
page 26-47
configure service vpls mesh-sdp ingress vc-label
Configures the static MPLS VC label used by the far-end router to send packets to this router using the
specified mesh SDP binding.
specified mesh SDP binding.
configure service vpls service-id mesh-sdp sdp-id[:vc-id] ingress vc-label ingress-vc-label
configure service vpls service-id no mesh-sdp sdp-id no ingress vc-label
Syntax Definitions
service-id
An existing VPLS ID number.
sdp-id
An existing SDP ID number that is bound to the specified service ID
number.
number.
vc-id
A VC ID number used to validate the VC ID portion of each mesh SDP
binding defined for the service.
binding defined for the service.
vc-label
The ingress VC value that identifies a specific connection. The valid
range is 2048–18431.
range is 2048–18431.
Defaults
By default, the ingress VC label value is set to zero (0).
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
Use the no form of this command to remove the ingress VC label from the specified VPLS.
Examples
-> configure service vpls 100 mesh-sdp 20 ingress vc-label 131069
-> configure service vpls 100 mesh-sdp 20 ingress no vc-label
Release History
Release 6.4.2; command was introduced.
parameter
default
vc-id
service-id value