Alcatel-Lucent 6850-48 参照ガイド
Ethernet OAM Commands
OmniSwitch CLI Reference Guide
September 2009
page 28-25
ethoam endpoint lowest-priority-defect
Configures the lowest priority fault alarm for the lowest priority defect for a MEP.
ethoam endpoint mep_id domain {domain_name | mac_address} association association_name lowest-
priority-defect lowest_priority_defect
priority-defect lowest_priority_defect
Syntax Definitions
mep_id
Specifies the Maintenance Association End Point. The valid range is
1–8191.
1–8191.
domain_name
Specifies the domain name. For more information on the different
formats of the domain name, refer to
formats of the domain name, refer to
mac_address
Specifies the CFM system MAC address.
association_name
Name of the Ethernet OAM Association. Up to 48 (minus the domain
name length) characters may be used.
name length) characters may be used.
lowest_priority_defect
The lowest priority defect that can generate a Fault alarm. Possible
values are xcon, rem-err-xcon, no-defect, mac-rem-err-xcon, err-xcon,
and all-defect.
values are xcon, rem-err-xcon, no-defect, mac-rem-err-xcon, err-xcon,
and all-defect.
Defaults
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
The mep_id should be unique amid all those used by or available to the service provider in the specified
MA.
MA.
Examples
-> ethoam endpoint 100 domain esd.alcatel-lucent.com association alcatel-sales
lowest-priority-defect all-defect
Release History
Release 6.3.1; command was introduced.
parameter
default
lowest_priority_defect
mac-rem-err-
xcon
xcon