Alcatel-Lucent 6850-48 参照ガイド
Ethernet Port Commands
page 19-96
OmniSwitch CLI Reference Guide
September 2009
show interfaces hybrid flow control
Displays interface flow control wait time settings for combo ports.
show interfaces [slot[/port[-port2]]] hybrid {fiber |copper} flow control
Syntax Definitions
slot
Slot number you want to display.
port
Port number of the interface you want to display.
port2
Last port number in a range of ports you want to display.
fiber
Specifies that the configuration of the SFP port(s) will be displayed.
copper
Specifies that the configuration of the copper 10/100/1000 RJ-45 port(s)
will be displayed.
will be displayed.
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850
Usage Guidelines
• If no slot/port numbers are entered, flow control wait time settings for all slots/ports on the switch are
displayed.
• You can display a specific interface by entering the slot and port number, a range of ports by entering a
slot and a range of ports, display all interfaces in a slot by entering the slot number, or display all inter-
faces as described above.
faces as described above.
• Note that the show interfaces hybrid flow control command is not supported on the OmniSwitch
6855. To view this type of information for the OmniSwitch 6855, use the
command.
Examples
-> show interfaces hybrid fiber flow control
Slot/Port Active Wait time(usec) Cfg-Flow Cfg-Cross
-----------+--------+---------------+--------+-----------
1/45 - 0 Pause MDI
1/46 - 0 Pause MDI
1/47 - 0 Pause MDI
1/48 - 0 Pause MDI
2/45 - 0 Pause MDI
2/46 - 0 Pause MDI
2/47 - 0 Pause MDI
2/48 - 0 Pause MDI