Printronix L5020 ユーザーズマニュアル
Chapter 2
Using The Control Panel
38
When the printer is in an error state, pressing ONLINE in any level
of the configuration menu causes the printer to re-display the fault
message.
of the configuration menu causes the printer to re-display the fault
message.
CLEAR Key
In the fault state, press the CLEAR key to clear errors and reset the
printer to the offline state (if all errors are cleared).
printer to the offline state (if all errors are cleared).
TEST Key
When the printer is offline, you can run a test print, as configured
under the Test Print menu (see page 89), by pressing the TEST
key. To stop the test print, press TEST again.
under the Test Print menu (see page 89), by pressing the TEST
key. To stop the test print, press TEST again.
Pressing TEST when the printer is online has no effect.
SHIFT Key
This key does not have a function of its own. It is combined with
other keys to modify their functions.
other keys to modify their functions.
PAGE EJECT Key
The PAGE EJECT key performs the following functions when the
printer is online:
printer is online:
When the JOB IN PROCESS status indicator lights steadily,
pressing PAGE EJECT causes the printer to print all data in the
printer. The page is then cut at the perforation (unless the Burst On
Eject option is disabled).
pressing PAGE EJECT causes the printer to print all data in the
printer. The page is then cut at the perforation (unless the Burst On
Eject option is disabled).
IMPORTANT
Do not press PAGE EJECT while JOB IN PROCESS is flashing,
or your print job might become misaligned.
or your print job might become misaligned.
When the JOB IN PROCESS status indicator flashes, pressing
PAGE EJECT causes the printer to attempt to print any data in the
buffer. The paper motion caused by the page eject operation may
interrupt the printing of data that is not currently in the buffer. Once
the paper motion has occurred, the data that was not yet in the
buffer should print. The page is then cut at the perforation (unless
the Burst On Eject option is disabled).
PAGE EJECT causes the printer to attempt to print any data in the
buffer. The paper motion caused by the page eject operation may
interrupt the printing of data that is not currently in the buffer. Once
the paper motion has occurred, the data that was not yet in the
buffer should print. The page is then cut at the perforation (unless
the Burst On Eject option is disabled).