Printronix l7032 ユーザーズマニュアル
2.3 Selecting Printer - Host I/O Interface
There are three methods of selecting the appropriate printer – host I/O interface configuration.
2.3.1 Selecting the Ethernet Interface Using DHCP* Auto-Configuration
2.3.1 Selecting the Ethernet Interface Using DHCP* Auto-Configuration
*Dynamic Host Configuration Protocol: enables automatic configuration of the ethernet interface
to the local area network.
to the local area network.
1. Set the power switch to O (Off).
2. Attach the ethernet interface cable (customer supplied) to the ethernet port at the rear of the
2. Attach the ethernet interface cable (customer supplied) to the ethernet port at the rear of the
printer.
3. Set the power switch to I (On). The printer will initiate its load routines and warm up. Wait
until you see the following message on the display:
“READY / ONLINE”
4. On the control panel, press the MENU button. The following message appears:
“MAIN MENU / CONFIGURATIONS”
5. Press the ◄ arrow until you see the following message:
“MAIN MENU / INTERFACE CFG”
6. Press the ▼ arrow. The display will show the following:
“INTERFACE CFG / Ethernet I/O”
Note: If the ethernet I/O is already selected skip steps 7 through 14 and resume at step 15.
Note: If the ethernet I/O is already selected skip steps 7 through 14 and resume at step 15.
7. Press SHIFT + ▼ simultaneously to Enable the ethernet interface. The display will show the
following:
“Ethernet I/O / Enable? NO yes”
“Ethernet I/O / Enable? NO yes”
8. Press the ◄ arrow until you see the following message:
“Ethernet I/O / Enable? no YES”
9. Press SHIFT + ▼ simultaneously to confirm your choice. The display will show:
“Ethernet I/O / Working…”
Then:
“Enable Ethernet / *RESTART PRINTER* ”
Then:
“Enable Ethernet / *RESTART PRINTER* ”
10. Set the power switch to O (Off), wait 10 seconds, then set the power switch to 1 (On).
11. When the display reads “READY / ONLINE” press the MENU button:
11. When the display reads “READY / ONLINE” press the MENU button:
“MAIN MENU / CONFIGURATIONS”
12. Press the ◄ arrow until you see the following message:
“MAIN MENU / INTERFACE CFG”
13. Press the ▼ arrow. The display will show the following:
“INTERFACE CFG / Ethernet I/O”
14. Press the ▼ arrow. The display will show the following:
“Ethernet I/O / DHCP Auto-Config”
15. Press the ▼ arrow. The display will show the following:
“DHCP Auto-Config / *Disabled”
16. Press the ▲ arrow. The display will show the following:
“DHCP Auto-Config / Enabled”
17. Press SHIFT + ▼ simultaneously to confirm your choice. The display will show:
“DHCP Auto-Config / Working…”
Then:
Then:
“DHCP Auto-Config / *Enabled”
The printer has automatically downloaded the address and mask information from your
network. The ethernet interface is now the active printer port. Go to the next step.
The printer has automatically downloaded the address and mask information from your
network. The ethernet interface is now the active printer port. Go to the next step.
18. Press the READY / STOP button twice to go to the READY / ONLINE state.
19. Now make and store a configuration printout that shows the ethernet addresses for this
19. Now make and store a configuration printout that shows the ethernet addresses for this
printer. Press the MENU button:
“MAIN MENU / CONFIGURATIONS”
20. Press the ◄ arrow until you see the following message:
“MAIN MENU / TEST PRINT MENU”
37