Manualsbrain.com
  1. マニュアル
  2. ブランド
  3. Printronix
  4. l7032
  5. ユーザーズマニュアル

Printronix l7032 ユーザーズマニュアル

ダウンロード
ページ / 182
 
21. Press the ▼ arrow. The display will show: 
“TEST PRINT MENU / Configuration” 
22. Press SHIFT + ▼ simultaneously to select the current printer configuration. The display will 
quickly show: 
“Configuration / Working…” 
Then: 
“Configuration / Ready to Print” 
Then: 
“TEST PRINT MENU / Configuration” 
23. Press the READY / STOP button twice to print the configuration: 
“Processing” 
Then: 
“Printing” 
24. Verify that the network parameters are assigned correctly to the printer NIC (network 
interface card) – shown on the configuration printout items under “Network Config.” To verify 
connectivity, at the DOS prompt type ping <IP Address>. Save the configuration printout 
with the printer documentation. 
 
2.3.2 Selecting the Ethernet Interface Manually 
 
1.  Set the power switch to O (Off). 
2.  Attach the ethernet interface cable (customer supplied) to the ethernet port at the rear of the 
printer. 
3.  Set the power switch to I (On). The printer will initiate its load routines and warm up. Wait 
until you see the following message on the display: 
 “READY / ONLINE” 
4.  On the control panel, press the MENU button. The following message appears: 
“MAIN MENU / CONFIGURATIONS” 
5.  Press the ◄ arrow until you see the following message: 
“MAIN MENU / INTERFACE CFG” 
6.  Press the ▼ arrow. The display will show the following: 
“INTERFACE CFG / Ethernet I/O” 
Note: If the ethernet I/O is already selected skip steps 7 through 14 and resume at step 15. 
7.  Press SHIFT + ▼ simultaneously to Enable the ethernet interface. The display will show the 
following: 
“Ethernet I/O / Enable? NO yes” 
8.  Press the ◄ arrow until you see the following message: 
“Ethernet I/O / Enable? no YES” 
9.  Press SHIFT + ▼ simultaneously to confirm your choice. The display will show: 
“Ethernet I/O / Working…” 
Then: 
“Enable Ethernet / *RESTART PRINTER* ” 
10. Set the power switch to O (Off), wait 10 seconds, then set the power switch to 1 (On). 
11. When the display reads “READY / ONLINE” press the MENU button: 
“MAIN MENU / CONFIGURATIONS” 
12. Press the ◄ arrow until you see the following message: 
“MAIN MENU / INTERFACE CFG” 
13. Press the ▼ arrow. The display will show the following: 
“INTERFACE CFG / Ethernet I/O” 
14. Press the ▼ arrow. The display will show the following: 
“Ethernet I/O / DHCP Auto-Config” 
15. Press the ◄ arrow. The display will show the following: 
“Ethernet I/O / Config Network” 
16. Press the ▼ arrow. The display will show the following: 
“Config Network / IP Address” 
38