Printronix SL5000e ユーザーズマニュアル
196
Chapter
3
Emulation Submenus
Absorb After ^PY
(From page 178.)
•
Absorb Motion. The paper motion line terminator immediately following
the graphics ^PY command will be ignored.
the graphics ^PY command will be ignored.
•
Absorb All. The system ignores all the data following ^PY until a host
generated terminator is detected and ignored.
generated terminator is detected and ignored.
•
Disable. System terminators following a graphics command are sent to
the printer and result in paper motion.
the printer and result in paper motion.
The factory default is Absorb Motion.
Active
(From page 183.)
•
Yes. When enabled, all data is parsed by the PPI2 emulation. Non-PPI2
data is absorbed.
data is absorbed.
•
No. When disabled, all data is passed to the LP+ emulation.
For information on setting the LP+ Text Mode through the host data stream,
refer to the
refer to the
PPI2 Programmer’s Reference Manual.
The factory default is Yes.
Active Char Set
(From page 158, page 161, page 170, page 173.) Selects which group of
character sets (Primary or Secondary) will be active.
character sets (Primary or Secondary) will be active.
The factory default is Secondary Set.
AI 00 Spaces
(From page 176.) This option is designated for EAN/UCC-128 barcodes
whose application identifier (AI) is 00.
whose application identifier (AI) is 00.
•
Disable. The printable data field is printed with the AI enclosed in
parentheses. This is the standard EAN/UCC-128 format.
parentheses. This is the standard EAN/UCC-128 format.
•
Enable. The printable data field is printed with the UCC fields separated
by spaces. This option is IGP-X00 compatible.
by spaces. This option is IGP-X00 compatible.
The factory default is Disable.
Alt. Char Set
(From page 192.)
•
Set 1. Interprets data in the range of hex 80 through hex 9F as a control
code.
code.
•
Set 2. Prints data in the range of hex 80 through hex 9F.
The factory default is Set 1.