Printronix SL5000 参照マニュアル
Forms Length Set (Lines)
101
Comment
Upon receipt of this code, the current line becomes the first line
of the form, and the form length set becomes the current forms
length. Vertical tab positions set below the bottom of the form
are ignored. Forms length is defined in inches; therefore,
subsequent line spacing changes do not affect the result of this
command.
of the form, and the form length set becomes the current forms
length. Vertical tab positions set below the bottom of the form
are ignored. Forms length is defined in inches; therefore,
subsequent line spacing changes do not affect the result of this
command.
The maximum forms length is 24 inches. All other values are
ignored.
ignored.
When forms length is set by the ESC C NUL sequence, the skip-
over perforation is set to zero.
over perforation is set to zero.
Forms length can also be set through the control panel. The
control code forms length setting from the host computer
overrides the control panel setting.
control code forms length setting from the host computer
overrides the control panel setting.
Forms Length Set (Lines)
ASCII Code ESC C
n
Hex Code
1B 43
n
Dec Code
27 67
n
Purpose
Sets the length of a form (paper) in lines.
where:
n = 1 through 192 (hex 01 through C0) to specify the number of
lines per page at the current line spacing.
lines per page at the current line spacing.
Comment
The forms length set becomes the current forms length. The
forms length units are always defined in inches; therefore,
subsequent line spacing changes do not affect the result of this
command. Changing lpi does not change the forms length.
forms length units are always defined in inches; therefore,
subsequent line spacing changes do not affect the result of this
command. Changing lpi does not change the forms length.
The forms length is set to the number of lines defined by the
quotient of
quotient of
n and the current line spacing so that the units are in
inches. If the calculated forms length in lines is not an exact
multiple of the target machine dot size, the forms length value is
adjusted down to the next possible multiple.
multiple of the target machine dot size, the forms length value is
adjusted down to the next possible multiple.
When forms length is set by the ESC C sequence, the skip-over
perforation is set to zero.
perforation is set to zero.