Printronix SL5000 参照マニュアル

 247

The modulo-10 check digit is automatically calculated and inserted in the bar 
code symbol. The check digit verifies accurate scanning. The number system 
character is included in the check digit algorithm.

The FIM (Facing Identification Mark) bar code structure is shown in Figure 13 
and described on the following pages. The left boundary must begin 3 inches 
from the right edge of the mail piece. The right-most bar must be 2 inches ± 1/
8-inch from the right edge of the mail piece. Bars are 5/8-inch ± 1/8-inch tall; 
the top of the bars must be no lower than 1/8-inch from the top edge of the 
mail piece (and may touch the top edge of the mail piece). The bar code 
baseline must be within 1/8-inch from the bottom edge of the clear zone.

NOTE: Additional information regarding FIM bar code requirements can be 

obtained from the U.S. Postal Service's Publication 25: 

A Manual to 

Business Mail Preparation.

The bar code structure requires a completely blank, 1-1/4-inch wide, 5/8-inch 
tall quiet zone, reserved for only the appropriate FIM pattern. You must 
provide sufficient space for this zone.

Return Address Area

5/8"

1-1/4"

(Optional Line)

(Top Line)

(Optional Line)

(Line Above Last)

(Last Line)

NON-ADDRESS DATA
NAME OF RECIPIENT
INFORMATION/ATTENTION LINE
DELIVERY ADDRESS
POST OFFICE STATE ZIP

xxxx,yyyy

1-3/4"

Quiet

3"

1/8"

2"- 1-7/8"

Zone

NOTE:   Illustration is not to 
scale.

Illustration is not to scale.