Printronix SL5000 参照マニュアル
54
Chapter
2
Configuring the P-Series Emulation with Control Codes
Print Mode/Pitch Selection
ASCII Code SFCC X
mnSFCC [ n qSFCC PMODE;n
Hex Code
SFCC 58
mnSFCC 5B n 71
Dec Code
SFCC 88
mnSFCC 91 n 113
Purpose
Selects the print mode (Letter Gothic, Courier, or OCR) and
character pitch in characters per inch (cpi).
character pitch in characters per inch (cpi).
where:
In SFCC PMODE;
n
n ranges from 0 through 6 to select the print mode/pitch
combinations available from Table 9. All other values result in an
error message. (Command Line Error Messages are listed in
Table 2 on page 25.)
combinations available from Table 9. All other values result in an
error message. (Command Line Error Messages are listed in
Table 2 on page 25.)
where:
In SFCC X
mn
m = Print Mode code
n = Pitch (cpi)
n = Pitch (cpi)
An asterisk (*) (hex 2A) may be substituted for
m or n. Whenever
the asterisk replaces
m or n, its current value does not change.
where:
In SFCC[
n q
n = Print Mode/Pitch code (values other than those shown in
Table 10 are ignored.)
Table 10 are ignored.)
q = Command sequence terminator
NOTE: The print mode must be changed before the first printable symbol of a
print line or the command sequence is deferred until the next line.
Comment
P-Series PMODE switches to the Primary Character Set and
selects print mode and pitch.
selects print mode and pitch.
Print mode and pitch can also be selected from the control
panel. The print mode/pitch select control code from the host
computer overrides the control panel print mode setting and the
print mode and pitch selection are reflected on the message
display.
panel. The print mode/pitch select control code from the host
computer overrides the control panel print mode setting and the
print mode and pitch selection are reflected on the message
display.
A complete set of tables identifying pitch and dot densities for all
print modes follows.
print modes follows.