Toshiba sd-v395kc オーナーマニュアル

  The DVD/VCR must be connected “between” the antenna and the TV. First, disconnect the antenna from the TV and 

connect it to the DVD/VCR. Then connect the DVD/VCR to the TV. Below are 3 common methods of connecting an 

antenna system to a DVD/VCR. Find the type of antenna system you are using and follow the connection diagram. 

DVD/VCR

75 ohm Coaxial Cable

300 ohm Twin Lead (Flat) Wire

(not supplied)

Matching Transformer 300 ohm Input 75 

ohm output (not supplied)

DVD/VCR

Note: If both VHF and UHF antennas have 300 ohm twin lead (flat) wires, use a combiner having two 300 ohm inputs and 

one 75 ohm output.

A clear picture will not be obtained by the DVD/VCR unless the antenna signal is good. Connect the antenna to

the DVD/VCR properly.

•

For better quality recording, an indoor antenna or a telescopic antenna is not recommended. The use of an outdoor 

type antenna is required.

•

If you are not sure about the connection, please refer to qualified service personnel.

•

If you are using an antenna system, follow these instructions. If you are a Cable TV subscriber, skip ahead to page 

 for 

the proper connections.

VHF

UHF

300 ohm Twin Lead (Flat) Wire

(not supplied)

75 ohm Coaxial Cable

Combiner 75/300 ohm Inputs 75 ohm output

(not supplied)

DVD/VCR

2K60121A.indb   14

2K60121A.indb   14

1/12/2007   3:50:05 PM

1/12/2007   3:50:05 PM