Toshiba sd-v395kc オーナーマニュアル

To play a pre-recorded tape.

Turn ON the TV and select the corresponding video 

input.

Press VCR DVD selector to select the VCR mode. (The 

VCR mode indicator will light).

•

•

Load a pre-recorded tape

(When loading a cassette tape without the erase 

prevention tab, playback will start automatically).

Press PLAY.

Playback will start. “ ▶ ” will appear on the screen 

for about 4 seconds.

Press STOP once.

The tape will stop but remain fully loaded and ready 

to play.

“■” will appear on the screen for about 4 seconds.

This VCR selects the playback tape speed SP, LP or SLP 

automatically.

The cassette tape and DVD disc can be played back 

simultaneously. If you press VCR DVD selector, the tape 

playback and DVD playback alternate with each other on 

the screen (via CH3, 4 or video connection).

•

•

Stop the playback via STOP on remote control.
To rewind the tape: 

Press REV.

Press FWD.

To discontinue the tape-winding, press STOP. To switch to 

playback directly (without STOP), press PLAY.

■

  Forward/Reverse picture search mode

When the tape is being winded, you can switch to picture 

search mode (see below). To do this, press REV or FWD 

and hold it down. The unit will resume the tape advance 

or rewinding as soon as the button is released.

Press REV once or twice during playback.

Press FWD once or twice during playback.

To resume normal playback, press PLAY.

TAPE SPEED

PICTURE SEARCH SPEED

PRESS ONCE

PRESS TWICE

SP (Standard Play)

3 X

5 X

LP (Long Play)

7 X

9 X

SLP (Super Long Play)

9 X

15 X

Press PAUSE/STEP during playback.

To resume normal playback, press PLAY or PAUSE/STEP.

During playback, press SLOW.

To resume normal playback, press PLAY.

If noise bars appear in the picture during slow motion, press 

SET +/– to reduce the noise bars.

If the still picture jitters excessively, press SET +/– to 

stabilize the still picture.

Press PAUSE/STEP during playback.

Press SLOW repeatedly. The picture advances frame by 

frame.

To resume normal playback, press PLAY or PAUSE/STEP.

Press CM SKIP during playback. The DVD/VCR will search 

forward through approximately 30 seconds of the tape (e.g. 

unwanted commercial time) for each press of CM SKIP 

(maximum six presses) and then resume normal playback.

For example :  1 press: 30 seconds of tape

 

2 press: 60 seconds of tape

 

3 press: 90 seconds of tape

Whenever you insert a tape and start playback, the 

automatic tracking feature continuously analyzes the 

signal to enable optimum picture quality during playback.

If automatic tracking cannot eliminate noises well during

playback, press SET +/– to eliminate the noise. “MANUAL 

TR.” will appear on the screen. Press it once for a fine 

adjustment, or press and hold for a coarse adjustment. 

Press ATR to reactivate automatic tracking again.

“AUTO TR.” will appear on the screen.

The audio output is muted during PICTURE SEARCH, 

STILL PICTURE, SLOW MOTION and FRAME BY FRAME 

PICTURE.

During picture search mode, there will be noise bars. This is 

not a defect.

Playback will commence after approx. 5 minutes to protect 

the video tape against excessive wear during pause mode.

•

•

•

2K60121A.indb   26

2K60121A.indb   26

1/12/2007   3:50:11 PM

1/12/2007   3:50:11 PM