Netgear FVL328 参照マニュアル

Connecting the FVL328 to the Internet

3-11

Manually configure the firewall in the Basic Settings menu using these steps:

•

Select Yes if you normally must launch a login program such as Enternet or WinPOET in 
order to access the Internet. You must also log in to establish a PPPoE connection that uses 
a Static IP address.

Note: If you are a Telstra BigPond cable modem customer, or if you are in an area such as 
Austria that uses PPTP, login is required. Select Yes, then select BigPond or PPTP from 
the Internet Service Type drop-down box.

•

Select No if you do not log in to establish your Internet connection.

 

If your Internet connection does not require a login, skip to step 3. 

–

Enter your Account Name (may also be called Host Name) and Domain Name. 

 

These parameters may be necessary to access your ISP’s services such as mail or news 
servers. These fields are case sensitive. 

–

If you want to change the login timeout, enter a new value in minutes. This determines 
how long the firewall keeps the Internet connection active after there is no Internet activity 
from the LAN. Entering an Idle Timeout value of zero means never log out.

–

If you want to disable NAT, select the Disable radio button. Before disabling NAT, back up 
your current configuration settings.

–

Domain Name Server (DNS) Address: 

 

If you know that your ISP does not automatically transmit DNS addresses to the firewall 
during login, select “Use these DNS servers” and enter the IP address of your ISP’s 
Primary DNS Server. If a Secondary DNS Server address is available, enter it also

–

If required, enter your Account Name (may also be called Host Name) and Domain Name. 

 

These parameters may be necessary to access your ISP’s services such as mail or news 
servers. The Account Name and Domain Name are not always required.

Disabling NAT will reboot the router and reset all the FVL328 configuration 

settings to the factory default. Disable NAT only if you plan to install the FVL328 in a 
setting where you will be manually administering the IP address space on the LAN side 
of the router.