Netgear FVL328 参照マニュアル
WAN and LAN Configuration
4-1
May 2004, 202-10030-02
Chapter 4
WAN and LAN Configuration
This chapter describes how to configure the WAN and LAN settings of your FVL328 Prosafe High
Speed VPN Firewall.
Speed VPN Firewall.
Configuring LAN IP Settings
The LAN IP Setup menu allows configuration of LAN IP services such as DHCP and RIP. These
features can be found under the Advanced heading in the Main Menu of the browser interface.
features can be found under the Advanced heading in the Main Menu of the browser interface.
The firewall is shipped preconfigured to use private IP addresses on the LAN side, and to act as a
DHCP server. The firewall’s default LAN IP configuration is:
DHCP server. The firewall’s default LAN IP configuration is:
•
LAN IP addresses—192.168.0.1
•
Subnet mask—255.255.255.0
These addresses are part of the IETF-designated private address range for use in private networks,
and should be suitable in most applications. If your network has a requirement to use a different IP
addressing scheme, you can make those changes.
and should be suitable in most applications. If your network has a requirement to use a different IP
addressing scheme, you can make those changes.
The LAN TCP/IP Setup parameters are:
•
IP Address
This is the LAN IP address of the firewall.
•
IP Subnet Mask
This is the LAN Subnet Mask of the firewall. Combined with the IP address, the IP Subnet
Mask allows a device to know which other addresses are local to it, and which must be reached
through a gateway or router.
Mask allows a device to know which other addresses are local to it, and which must be reached
through a gateway or router.
Note:
If you change the LAN IP address of the firewall while connected through the
browser, you will be disconnected. You must then open a new connection to the new IP
address and log in again.
address and log in again.