Netgear FVS336G 参照ガイド

2-1

The initial Internet configuration of the ProSafe Dual WAN Gigabit Firewall with SSL & IPsec 
VPN is described in this chapter.

This chapter contains the following sections:

•

•

•

•

•

•

•

Typically, six steps are required to complete the basic Internet connection of your VPN firewall.

1. Connect the firewall physically to your network. Connect the cables and restart your 

network according to the instructions in the installation guide. See the Installation Guide, 
FVS336G ProSafe Dual WAN Gigabit Firewall with SSL & IPsec VPN for complete steps. A 
PDF of the Installation Guide is on the NETGEAR website at: 

2. Log in to the VPN Firewall. After logging in, you are ready to set up and configure your 

VPN firewall. You can also change your password and enable remote management at this 
time. See 

.

3. Configure the Internet connections to your ISP(s). During this phase, you will connect to 

your ISPs. You can also program the WAN traffic meters at this time if desired. See 

.