Netgear FVS336G 参照ガイド
ProSafe Dual WAN Gigabit Firewall with SSL & IPsec VPN FVS336G Reference Manual
2-2
Connecting the FVS336G to the Internet
v1.0, October 2007
4. Configure the WAN mode (required for dual WAN operation). Select either dedicated
(single WAN) mode, auto-rollover mode, or load balancing mode. For load balancing, you can
also select any necessary protocol bindings. See
also select any necessary protocol bindings. See
.
5. Configure dynamic DNS on the WAN ports (optional). Configure your fully qualified
domain names during this phase (if required). See
.
6. Configure the WAN options (optional). Optionally, you can enable each WAN port to
respond to a ping, and you can change the factory default MTU size and port speed. However,
these are advanced features and changing them is not usually required. See
these are advanced features and changing them is not usually required. See
.
Each of these tasks is detailed separately in this chapter. The configuration of firewall and VPN
features is described in later chapters.
features is described in later chapters.
Logging into the VPN Firewall Router
To connect to the VPN firewall, your computer needs to be configured to obtain an IP address
automatically from the VPN firewall by DHCP. For instructions on how to configure your
computer for DHCP, refer to the link in
automatically from the VPN firewall by DHCP. For instructions on how to configure your
computer for DHCP, refer to the link in
To connect and log in to the VPN firewall follow these steps:
1. Start any of the qualified browsers, as detailed in
.
2. Enter https://192.168.1.1 in the address field.