Netgear wgr101 参照マニュアル

ページ / 123
February 2005 (202-10034-03)
iii
Federal Communications Commission (FCC) Compliance Notice: Radio 
Frequency Notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to 
 
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a 
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and 
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no 
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to 
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try 
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help. 
FCC Caution
1.
FCC RF Radiation Exposure Statement: The equipment complies with FCC RF radiation exposure limits set forth 
for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 
centimeters between the radiator and your body. 
2.
This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 
3.
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the 
user authority to operate the equipment.
Europe - EU Declaration of Conformity
This device is a 2.4 GHz low power RF device intended for home and office use in EU and EFTA member states. In 
some EU / EFTA member states some restrictions may apply. Please contact local spectrum management authorities for 
further details before putting this device into operation.
Marking by the above symbol indicates compliance with the Essential Requirements of the R&TTE Directive of the 
European Union (1999/5/EC). This equipment meets the following conformance standards:
EN300 328, EN301 489-17,  EN60950