Netgear WNR2000 インストール手順

16

Manually Installing Your Router

When configuring your wireless router manually, you must log in to your wireless router to set it 
up initially and to make any changes to your wireless router’s settings later.

Type http://www.routerlogin.net in the address field of your browser, and then click Enter.

The factory default state is reset when you use the Restore Factory Settings button. 
See 

more information.

You can enter either of these addresses to connect to your wireless router:

http://www.routerlogin.net or http://www.routerlogin.com.

WPS. The WPS button/light will not be lit unless you push it to enable
Push ‘N’ Connect (WPS) security. See 

.

Power. The power light should turn solid green. If it does not, see 

Wireless. The wireless light should be lit after turning on the 
router.

Internet. The Internet port light should be lit. If it is not, make sure the
Ethernet cable is securely attached to the wireless router Internet port
and the modem, and that the modem is powered on.

LAN. A LAN light (1-4) should be lit for each connected computer on 
your network. Green indicates that your computer is communicating 
at 100 Mbps; amber indicates communication at 10 Mbps. If a LAN 
light is not lit for each connected Ethernet cable, make sure that the 
Ethernet cable from the computer to the router is securely attached 
at both ends, and that the computer is turned on.