Mitsubishi pd-5030 ユーザーズマニュアル

17

Use these settings if the picture has noise due to poor
reception or when playing video tapes with poor picture
quality.
Example: Setting “NR-3”

1. On the MAIN MENU, select “VIDEO SETTINGS”,

then press the MENU/ENTER button.
The “VIDEO SETTINGS” screen appears.

2. Use the 

▲ and ▼ buttons to select “NR”.

3. Use the 

  and  

 buttons to select “NR-3”.

The mode switches as follows each time the 

 or 

button is pressed:

→ OFF ↔ NR-1 ↔ NR-2 ↔ NR-3 ←

* If neither the 

 or 

 button is pressed within 5 seconds,

the current selection is stored into memory and the
previous screen reappears.

 NR
* “NR” stands for Noise Reduction.
* This function reduces noise in the picture.

 Types of noise reduction
There are three settings for noise reduction. Each has a
different level of noise reduction.
The effect becomes stronger as the number increases
(in the order NR-1 → NR-2 → NR-3).
OFF ............... Turns the noise reduction function off.

Use this procedure to set color tone produced by the plasma
display.
Example: Setting “HIGH”

1. On the MAIN MENU, select “VIDEO SETTINGS”,

then press the MENU/ENTER button.
The “VIDEO SETTINGS” screen appears.

2. Use the 

▲ and ▼ buttons to select “NEXT PAGE”.

3. Select “COLOR TEMP”.

4. Use the 

 and 

 buttons to select “HIGH”.

The mode switches as follows each time the 

 or 

button is pressed:

→ LOW ↔ MID LOW ↔ MEDIUM ↔ HIGH ←

* See below to set “WHITE BALANCE”.

* If neither the 

 or 

 button is pressed within 5 seconds,

the current selection is stored into memory and the previous
screen reappears.

 Setting the color temperature
LOW ................ Redder
MID LOW ......... Slightly redder
MEDIUM ........... Standard (slightly bluer)
HIGH ............... Bluer

 Restoring the factory default settings
Select “ALL RESET” under the OPTION1 menu. Note
that this also restores other settings to the factory defaults.

Use this procedure to adjust the white balance for each
color temperature to achieve the desired color quality.
Example: Adjusting the “GAIN RED” of “HIGH” color
temperature

5. Press the MENU/ENTER button.

The “WHITE BALANCE” screen appears.

6. Use the 

▲ and ▼ buttons to select “GAIN RED”.