Champion usn-72 ユーザーガイド

Part 3: OPERATION

3.3 Start-Up Procedure

Perform the following steps to start up the dishwasher for first-time operation.

CAUTION:

Perform the following checks before placing the machine into service.

1. Check the exterior of the machine for any foreign material, and remove.

NOTE:

To remove the dishwasher lift-out doors:

Grasp the handles and lift approximately 4".

Tilt the top of the door toward you and out of the door track.

2. Remove the lift-out doors.
3. Check the interior of the machine and remove any foreign material.

NOTE:

To install the upper and lower spray pipes:

Insert the pipe into its locking plate and turn 1/4 turn clockwise.

Each pipe has an o-ring on the end of its manifold.

4. Make sure the upper and lower spray arms are secure in the manifold

and all end plugs are in place.

5. Remove the scrap screens and make sure all overflow covers are down

and the pump intake screens are in place.

6. Replace the scrap screens.

NOTE:

Dishwasher curtains have long and short flaps.

Be sure the short flaps of all curtains face the load end of the machine.

Place long curtains at the load and unload ends of the dishwasher.

Place the short curtain at the end of the wash tank in the center of the dishwasher.

7. Make sure the curtains are in place.
8. Reinstall the lift-out doors.
9. Check the chemical injection system (if applicable).

10. Close the tank drain valves along the lower front of the machine.

11. Open the water supply valves. Check for leaks and take corrective action if required.