Roland juno-stage ユーザーガイド

 

OFF, ON

Determines whether the internal sound generator is disconnected (OFF) from the controller section 
(keyboard, pitch bend/modulation lever, knobs, buttons, D Beam controller, pedal, and so on); or 
not disconnected (ON).

Normally this is left “ON,” but if you wish to use the JUNO-STAGE’s keyboard and controllers 
to control only external sound modules, set it to “OFF.”

 

17–32

When you want to transmit or receive System Exclusive messages, set this parameter to match the 
Device ID number of the other MIDI device.

 

OFF, ON

Set this parameter “ON” when you want to use an external MIDI keyboard instead of the 
JUNO-STAGE’s keyboard.

In this case, the MIDI transmit channel of the external MIDI keyboard can be set to any channel. 
Normally you will leave this parameter “OFF.”

* Turn this “ON” when you want to control the JUNO-STAGE from an external MIDI device when 

performing with the Arpeggio function.

 

1–16, OFF

Selects the MIDI receive channel used during switching of performances when MIDI messages 
(Program Change/Bank Select) are sent from an external MIDI device.

Set this to “OFF” if performances are not to be switched from an external MIDI device.

* If only a program change is received, and if this parameter setting coincides with the MIDI 

receive channel of a part, priority will be given to switching the performance.

 

1–16

Channel used to transmit and receive MIDI messages for the Keyboard part in Patch mode

 

OFF, ON

If this is “ON,” incoming MIDI messages will be re-transmitted without change from the MIDI OUT 
connector.

 

OFF, ON

Specifies whether Program Change messages will be transmitted (ON) or not (OFF).

 

OFF, ON

Specifies whether Bank Select messages will be transmitted (ON) or not (OFF).

 

OFF, ON

Specifies whether Active Sensing messages will be transmitted (ON) or not (OFF).

 

OFF, ON

Specify whether changes you make in the settings of a patch, performance will be transmitted as 
system exclusive messages (ON), or will not be transmitted (OFF).

 

OFF, ON

Thru function re-transmits all messages received at the MIDI IN connector to the MIDI OUT 
connector without modifying them in any way.

fig.LocalSw.e

When you’re using the JUNO-STAGE with external sequencer software, leave the Local 
Switch turned off. Read the following for details.
Typically, things are hooked up so the data travels as follows: the JUNO-STAGE’s 
keyboard 

→ your external sequencer software → the JUNO-STAGE’s sound generator. 

Normally, the JUNO-STAGE’s keyboard section is internally connected to its sound 
generator section; this internal connection is controlled by the Local Switch. If you turn 
the Local Switch off, the JUNO-STAGE’s keyboard and sound generator sections will be 
independent, allowing you to use the connection described with your external 
sequencer software.

Local Off

(External)

Sequencer

JUNO-STAGE

Keyboard

JUNO-STAGE

Sound Generator

JUNO-STAGE_e.book 150 ページ ２００８年１０月１７日　金曜日　午後１２時２７分