Roland RS-70 オーナーマニュアル
121
Using the floppy disk drive
Floppy Disk
3.
Use PAGE/CURSOR [
]/[
] to select “2:SAVE.”
fig.r11-13_40
4.
Press [ENTER].
5.
Use VALUE [-]/[+] to select “Type:ALL.”
fig.r11-14_40
6.
Press PAGE/CURSOR [
] to go to the next page.
7.
Assign a file name.
The file will be saved with an extension of “.RSU”.
8.
Press [ENTER].
If you decide to cancel, press [EXIT].
When the user memory has been saved, the display will indicate
“COMPLETED.” This ends the procedure.
“COMPLETED.” This ends the procedure.
Saving the current pattern as an SMF
SMF data that includes a copyright notice cannot be re-saved as
a user pattern or SMF.
a user pattern or SMF.
When you save as SMF data, data for muted parts will not be
saved.
saved.
1.
Insert a disk into the floppy disk drive.
2.
Press [WRITE] while holding down [SHIFT].
3.
Use PAGE/CURSOR [
]/[
] to select “2:SAVE.”
fig.r11-15_40
4.
Press [ENTER].
5.
Use VALUE [-]/[+] to select “Type:SMF.”
fig.r11-16_40
6.
Press PAGE/CURSOR [
] to go to the next page.
7.
Assign a file name.
The file will be saved with an extension of “.SMF”.
is not possible to use lowercase characters or some symbols
(space, “ * + , . / : ; < = > ? [ ¥ ]) in filenames.
(space, “ * + , . / : ; < = > ? [ ¥ ]) in filenames.
8.
Press [ENTER].
If you decide to cancel, press [EXIT].
When the current pattern has been saved, the display will indicate
“COMPLETED.” This ends the procedure.
“COMPLETED.” This ends the procedure.
Preparing a disk for use by the RS-70
(FORMAT)
This function initializes (
formats
) a disk so that RS-70 data can be
saved to it. Before a new disk or a disk used on another device can be
used on the RS-70, it must be formatted on the RS-70.
used on the RS-70, it must be formatted on the RS-70.
Be aware that if you format a disk, all of the data in the disk will
be lost.
be lost.
Master disk releases of Standard MIDI Files from Roland, etc.
cannot be formatted.
cannot be formatted.
1.
Insert a disk into the floppy disk drive.
2.
Press [WRITE] while holding down [SHIFT].
3.
Use PAGE/CURSOR [
]/[
] to select “3:FORMAT.”
fig.r11-17_40
4.
Press [ENTER].
5.
Assign a volume label.
is not possible to use lowercase characters or some symbols (“ * +
, . / : ; < = > ? [ ¥ ]) in volume labels.
, . / : ; < = > ? [ ¥ ]) in volume labels.
6.
Press [ENTER].
If you decide to cancel, press [EXIT].
When the disk has been formatted, the display will indicate
“COMPLETED.” This ends the procedure.
“COMPLETED.” This ends the procedure.
RS-70_e4.book 121 ページ 2003年8月18日 月曜日 午前9時47分