Pro-Team coachvac ユーザーガイド

EN

G

LI

SH

ProTeam Owner’s Manual  –  

5.  Choose one of the following ways to wear the TailVac:

(1) Wrap the waist belt up in the envelope-style packet, and carry the TailVac by the
molded top handle.

(2) Connect the monostrap and sling it over the shoulder.

(3) Wear the TailVac around the waist with or without the monostrap for support.

6.  Detach the Velcro strap (a) from the base of the waistbelt and lift the strap (Figure F).

7.  Slide the Velcro strap (a) under the molded plastic handle of the vacuum and back over

the top of the handle. Attach the end of the strap to the Velcro tab (b) (Figure G).

8.  With the waistbelt facing you, use your right hand to separate the exposed Velcro

between the end of flap (c) and the back of the belt (Figure H).

9.  Continue to slide your right hand all the way to the left to separate the remaining Velcro

(Figure I). With your left hand, pull the flap (c) out from behind the waistbelt and toward
you to expose flap (d).

NOTE: If Monostrap is not attached, attach it now. Attach the hook on the short end of
the Monostrap to the ring up on the end of the Velcro strap (a). Attach the hook on the
other end of the monostrap to any of the four rings on (d) the waistbelt. Attach to rings
on flap (d) if right-handed, or flap (c) if left-handed.

10.  Slide the Monostrap (e) up over your preferred shoulder. Fasten the belt by bringing the

right flap (d) across the front. Then bring the left flap (c) over on top of it. (Figure J).

11.  Adjust the comfort of the shoulder strap (e) by adjusting the length of the strap and/or

attaching the front snap hook to any of the other rings on the front of the waistbelt (f)
(Figure K). NOTE: For maximum comfort, alternate the shoulder strap to the right or left
shoulder every two hours.