Pro-Team govac bp ユーザーガイド
O P E R A T I O N
8
PREPARING THE VACUUM FOR OPERATION
Figure A
Figure B
Figure C
Figure D
Figure E
Figure F
1.
Verify the charge level of the battery
pack by pressing the power level indi-
cator button on the inside of the pack
(Figure A). A fully charged battery pack
will display 5 green lights.
pack by pressing the power level indi-
cator button on the inside of the pack
(Figure A). A fully charged battery pack
will display 5 green lights.
2.
If no charge is needed, unhook the
shoulder straps from the waist belt on
the vacuum cleaner (Figure B).
shoulder straps from the waist belt on
the vacuum cleaner (Figure B).
3. Lay the shoulder straps over the top of
the vacuum so they are out of the way
(Figure C).
(Figure C).
4. Lift the battery pack over the back of
the vacuum making sure the inside of
the battery pack is faced towards the
back of the vacuum (Figure D).
the battery pack is faced towards the
back of the vacuum (Figure D).
5. Lower the battery pack into place by
sliding it in between the two alignment
plates on the vacuum waist belt assem-
bly (Figure E).
plates on the vacuum waist belt assem-
bly (Figure E).
6. While sliding the battery pack into
place, make sure the power connector
is fully locked into place with the vacu-
um connection (Figure F). Both power
connectors on the inside of battery
pack should be flush.
is fully locked into place with the vacu-
um connection (Figure F). Both power
connectors on the inside of battery
pack should be flush.
7.
Re-connect shoulder straps for operation.