Zhone 1752 shdsl ユーザーズマニュアル

interface in its egress interface list. 

User priority 

The user priority to regenerated user-priority 
mapping for a bridge interface. 

0 

Transport 

Name of attached transport. 

 

Priority map 

The mapping of user priority in the incoming 
frames to the regenerated user priority that would 
be used for traffic class mapping as well as set in 
the VLAN tag of the outgoing frame. How to 
configure is introduced in the following section. 

 

Click on priority map for a specified bridge interface, and then the Priority Map for the bridge 
interface page is displayed. In this page, number of traffic classes, user priority to 
regenerated priority map and Regenerated Priority to Traffic Class Map are provided to 
configure. The procedure is shown as follows: 

1.  Number of traffic classes, as shown in the following figure, specifies the number of traffic 

classes supported by the bridge interface. It can be any value between 1 and 8. 

 

2.  User Priority to Regenerated Priority Map, as shown is the following figure, specifies the 

mapping of user priority in the incoming frames to the regenerated user priority that would 
be used for traffic class mapping as well as set in the VLAN tag of the outgoing frame. 

      

 

The following table gives the range of values for each option which can be specified with this 
command and a default value. 

Option 

Description 

Default value

 

Priority 0 

The regenerated user-priority to which the user 
priority with value 0 in the incoming frame should 
be mapped.  

0 

68                                                                              June 2005                                                              1752-A2-GB20-00