Zhone 2000 ユーザーガイド
128
2 0 0 0 - A 2 - G B 2 3 - 0 0
port that carries IP traffic. On the IAD, it can be one of the following:
Ethernet port, PPP connection, ATM PVC, or FR DCLI.
IP Filtering can selectively pass or discard IP packets based on one or more of
the following properties:
Ethernet port, PPP connection, ATM PVC, or FR DCLI.
IP Filtering can selectively pass or discard IP packets based on one or more of
the following properties:
•
Protocol (IP, ICMP, TCP, and UDP)
•
Protocol flags (for TCP and ICMP only)
•
Source and/or Destination IP address
•
Source and/or Destination port number
For more information on defining and using a filter rule set, see IP Filtering
Application note on page C-252.
For more information, see Configure IP Filtering on page 4-91.
Application note on page C-252.
For more information, see Configure IP Filtering on page 4-91.
DHCP Server Configuration
This section describes the tasks required to configure the Dynamic Host
Configuration Protocol (DHCP) server on the LAN connection.
DHCP allows for dynamic allocation of network addresses and configurations
to newly attached hosts. DHCP reduces the amount of work required to
administer a large network.
Configuration Protocol (DHCP) server on the LAN connection.
DHCP allows for dynamic allocation of network addresses and configurations
to newly attached hosts. DHCP reduces the amount of work required to
administer a large network.
Basic DHCP Server Setup Tasks
When DHCP is enabled, it dynamically assigns an IP address to each device
assigned to the DHCP server on the IAD. You must identify the Ethernet
Interface to correctly implement DHCP Server on your IAD.
You must complete at least these tasks to configure the DHCP server:
assigned to the DHCP server on the IAD. You must identify the Ethernet
Interface to correctly implement DHCP Server on your IAD.
You must complete at least these tasks to configure the DHCP server:
•
Enable DHCP (default is disabled) (page 4-129)
•
•
Configure the DHCP address range pool (page 4-130)
DHCP Server Configuration Menu
The DHCP Server commands are all displayed on the DHCP Server
Configuration menu, which is displayed by typing “D” on the Main menu.
Configuration menu, which is displayed by typing “D” on the Main menu.
Remember always to reset the IAD when you have finished making DHCP
Server configuration changes.
Server configuration changes.