Zhone 2000 ユーザーガイド
C o n f i g u r a t i o n
143
6
Type the translated port number (range = 1-65535) and press Enter. The
IAD prompts you to enter the Local Server Standard Port number:
7
Type the Standard Port Number (range = 1-65535) and press Enter. If you
did not choose TCP and UDP for protocol, the IAD displays the following
message:
Updating NAT Local Server entry 1, Translated IP address
95.4.4.4
Translated Port 100 is accessible as Standard Port 65535
If you chose TCP and UDP for protocol, the IAD prompts you to enter the
number of consecutive ports to use.
number of consecutive ports to use.
8
Type the number of consecutive ports to use and press Enter. The IAD
displays a port report, saves the NAT configuration, and displays the NAT
Configuration menu.
9
Continue with other NAT configuration tasks, or press Escape to return to
the Main menu.
Configure NAT Alias Entry
Each NAT alias entry allows a device on the LAN (inside of NAT) to be
accessible from the Internet via a unique IP address. The IAD only translates
IP addresses for alias entries—port numbers are not changed.
You can create up to seven direct public-to-private IP address mappings via
the NAT alias table.
First, assign each public IP address using option C
accessible from the Internet via a unique IP address. The IAD only translates
IP addresses for alias entries—port numbers are not changed.
You can create up to seven direct public-to-private IP address mappings via
the NAT alias table.
First, assign each public IP address using option C
− Configure Port IP
Address on the Router Configuration menu (Figure 4.51)
− to entries 1
through 7 on the PVC or DLCI with a 255.255.255.255 subnet mask. Next,
make alias entries to map each local IP address to a corresponding public IP
address.
These NAT alias entries allow IP traffic to the public IP address to pass
directly through, port for port, to the corresponding private IP address.
To configure each NAT alias entry, follow the steps below.
make alias entries to map each local IP address to a corresponding public IP
address.
These NAT alias entries allow IP traffic to the public IP address to pass
directly through, port for port, to the corresponding private IP address.
To configure each NAT alias entry, follow the steps below.
1
Type “A” on the NAT Configuration menu to select Configure NAT Alias
Entry. The IAD displays the next unassigned entry and prompts you to enter
the NAT Alias Entry to configure.
2
Type the number of the alias entry to configure. The IAD displays the
current local IP address and prompts you to enter a new NAT Alias Local IP
Address.
3
Type the IP address of the device on the LAN. (It must be a statically
assigned IP address; do not use DHCP to assign this address.) The IAD
displays the current Internet IP Address and prompts you to enter a new one.
4
Type the new NAT alias IP address and press Enter. The IAD displays the
information you’ve entered and updates the configuration.
5
When the operation is complete, press any key to display the NAT
Configuration menu.